The Notifier B710LP/B710LPA base is intended for use in a 2-wire intelligent system, with screw terminals provided for power (+ and –), and remote annunciator connections. Also, Communication takes place over the power (+ and –) lines. The base is suitable for use with panel Model AM2020, Loop Interface Board, LIB-200; compatiblity ID;A maximum number of detectors per loop is 99. Besides, the Plug-in Detector Base is use with Notifier models CPX-751 and CPX-751A ionization and SDX-751 and SDX-751A photoelectronic detectors.
The Notifier B710LP detector base mounts directly to 3-1/2 inch and 4 inch octagon boxes, 4 inch square boxes (with or without plaster rings) and single gang boxes. To mount, remove the decorative ring by turning it in either direction to unhook the snaps, then separate the ring from the base. Install the base to the box using the screws supplied with the junction box and the appropriate mounting slots in the base. Place the decorative ring onto the base, then turn in either direction until the ring snaps in place.
Features / Specifications
- Diameter: 6.1 inches (15.5 cm)
- Voltage Range: 15 – 32 Volts DC Peak
- Standby Current (nominal): 150 µA at 24 VDC
- Max. Rated Voltage: 1.5 mA-sec
- LED Current (nominal): 6.5 mA at 24 VDC
Reviews
There are no reviews yet.