Siemens DB-3S from Siemens Fire Safety is a low-profile surface-mounting base also used on Siemens ionization detectors. Furthermore, each Siemens DB-3S base utilizes screw-clamp terminals for all electrical connections, self-wiping contacts for reliability, and contains a provision for an optional, concealed locking mechanism that prevents unauthorized removal of the detector head.
This detector base is commonly used on the following Siemens – Fire Safety fire alarm control panels: TXR-320, System 3, and SXL. Model DB-3S UL 1481, ULC Listed, as well as Factory Mutual (FM) and California State Fire Marshals’ (CSFM), Approved. Besides, the detector is provided with a separate base which attaches to a standard 4 inch square, 4 inch octagonal, or single gang electrical box, with the box size and depth required by the NEC for the number and the size conductors used
Mounting – Using the DB-3S
- Route all wires outward from the outlet box
- When the ALARM LED viewing is critical, position the LED mark in the base in the intended direction
- Mount base to the outlet box and route wires through the hole in the center of the base. Make connections directly to the base terminals.
- After all, bases are installed, including the end of the line device, check loop continuity. To make possible the continuity check, a jumper is furnish in every bas to complete the loop. An open circuit condition exists until the jumper or detector is install in the base.
- If loop continuity is acceptable, remove the jumper at each base and proceed with detector head installation
- To ensure proper installation of the detector head into the base:
- Properly dress all wires
- Position all wires flat against the base
- Take up all slack in the outlet box
- Route wires away from connector terminals
Reviews
There are no reviews yet.