Notifier PSE-6R Remote Power Supply (New w/Cab)

Notifier PSE-6R. New with metal box/cabinet.

The PS Series i s a remote power supply line from NOTIFIER. It’s a remote power supply with a battery charger that may b e connected to any 12 or 24-volt fire alarm control panel (FACP). Or used as a standalone power supply. The PS Series provides 24 VDC power for NACs (notification appliance circuits) configured as Class B or Class A (requires the ZNAC-PS option card) with multiple sync protocol options.

Up to five (6 amp model) or seven (10 amp model) independently-configurable, power-limited output circuits for:
Converts from Class B to Class A wiring without losing any outputs using the ZNAC-PS converter card (sold separately)
Optimal for powering four-wire smoke detectors, annunciators, and other system peripherals requiring regulated power
Configurable for ANSI® Temporal 3 or Temporal 4 coded output
UL-Listed NAC synchronization using System Sensor®, Wheelock®, Gentex®, or AMSECO® appliances
Synchronization can b e triggered from FACP NAC/remote sync outputs, cascaded power supply. Or a control module, single or multi, which may b e housed within the power supply cabinet
Ability to cascade up to four power supplies
Two (6 amp model) or three (10 amp model) fully-isolated input/ control circuits. Which can b e programmed to any output
Two Form C normally-closed trouble relays for AC Trouble and General Trouble, Ground Fault relay available on Canadian models only
6 or 10 amp full load output, respectively, with 3 A maximum/circuit
Individual NAC power and trouble LEDs for diagnostic efficiency
Trouble history modes for diagnostic support
Wide range end-of-line supervision value (normal: 2K-27K ohms)
Selectable earth fault detection (enable or disable)
AC trouble report delay timer

Datasheet