Notifier PSE-6 Remote Power Supply (New w/Cab)

New PSE-6 with metal box/cabinet.

The PS Series is a remote power supply line from NOTIFIER. It’s a remote power supply with a battery charger that may be connected to any 12 or 24-volt fire alarm control panel (FACP). Or used as a standalone power supply. The PS Series provides 24 VDC power for NACs (notification appliance circuits) configured as Class B or Class A (requires the ZNAC-PS option card) with multiple sync protocol options.

Up to five (6 amp model) or seven (10 amp model) independently-configurable, power-limited output circuits for:
Converts from Class B to Class A wiring without losing any outputs using the ZNAC-PS converter card (sold separately)
Optimal for powering four-wire smoke detectors, annunciators, and other system peripherals requiring regulated power
Configurable for ANSI® Temporal 3 or Temporal 4 coded output
UL-Listed NAC synchronization using System Sensor®, Wheelock®, Gentex®, or AMSECO® appliances
Synchronization can b e triggered from FACP NAC/remote sync outputs, cascaded power supply. Or a control module, single or multi, which may be housed within the power supply cabinet
Ability to cascade up to four power supplies
Two (6 amp model) or three (10 amp model) fully-isolated input/ control circuits. Which can be programmed to any output
Two Form C normally-closed trouble relays for AC Trouble and General Trouble, Ground Fault relay available on Canadian models only
6 or 10 amp full load output, respectively, with 3 A maximum/circuit
Individual NAC power and trouble LEDs for diagnostic efficiency
Trouble history modes for diagnostic support
Wide range end-of-line supervision value (normal: 2K-27K ohms)
Selectable earth fault detection (enable or disable)
AC trouble report delay timer

Datasheet