Notifier PSE-10R Remote Power Supply (New w/Cab)

Notifier PSE-10R. New with metal box/cabinet. (Red)

The PS Series is a remote power supply line from NOTIFIER and is a direct replacement for the FCPS-24S6/8 Series.
It can hold two 7 AH or 18 AH batteries. And charge up to 33 AH batteries in a separate cabinet. The PSE-6E and PSE-10E are models rated for 240V operation.
Features
Up to five (6 amp model) or seven (10 amp model) independently-configurable, power-limited output circuits for:
– Class B and/or Class A NACs
– Class B and/or Class A resettable or non-resettable 24V auxiliary power
– door holder power
Converts from Class B to Class A wiring without losing any outputs using the ZNAC-PS converter card (sold separately) Optimal for powering four-wire smoke detectors, annunciators, and other system peripherals requiring regulated power Configurable for ANSI® Temporal 3 or Temporal 4 coded output UL-Listed NAC synchronization using System Sensor®, Wheelock®, Gentex®, or AMSECO® appliances
Synchronization can b e triggered from FACP NAC/remote sync outputs and cascaded power supply. Or a control module, single or multi, which may b e housed within the power supply cabinet. Ability to cascade up to four power supplies .Two (6 amp model) or three (10 amp model) fully-isolated input/ control circuits can b e programmed to any output Two Form C normally-closed trouble relays for AC Trouble and General Trouble, Ground Fault relay available on Canadian models only 6 or 10 amp full load output, respectively, with 3 A maximum/circuit Individual NAC power and trouble LEDs for diagnostic efficiency.
Trouble history modes for diagnostic support Wide range end-of-line supervision value (normal: 2K-27K ohms) Selectable earth fault detection (enable or disable).

Datasheet