System Sensor B210LP is a plug-in detector base intended for use in a 2-wire intelligent system. Also, screw terminals provided for power and remote annunciator connection. Furthermore, communication takes place over the power lines.
This System Sensor B210LP detector base mounts directly to 4-inch square (with and without plaster rings), 4-inch octagon, 3 1/2-inch octagon, as well as single gang junction boxes. To mount, remove the decorative ring by turning it in either direction to unhook the snaps, then separate the ring from the base. Install the base on the box using the screws supplied with the junction box and the appropriate mounting slots in the base.
All wiring must be install in compliance with all applicable local codes and any special requirements of the authority having jurisdiction. Proper wire gauges should be use. Besides, the conductors used to connect smoke detectors to control panels and accessory devices should be color-coded to reduce the likelihood of wiring errors. Improper connections can prevent a system from responding properly in the event of a fire.
For signal wiring, it is recommend that the wire be no smaller than 18 AWG (0.823 square mm). Wire sizes up to 12 AWG (3.31 square mm) may be use with the base.
Features / Specifications
- Base Diameter: 6.1 inches (155 mm)
- Base Height: .76 inches (19 mm)
- Operating Voltage: 15 to 32 VDC
- Standby Current: 170 µA
Reviews
There are no reviews yet.